The Details Of How To Iron On Clothes
The embroidered chapter should be kept clean before the hot side, and the temperature should be adjusted to the temperature of the suitable clothing according to the method of the iron.
Put the embroidery chapter in the appropriate position of the demand (the glue does not tear off), hot a few times back and forth, ordinary hot for about 15 seconds can be
In order to avoid burns, you can put a thin cotton cloth on the embroidered chapter. After the hot finish, check the edge to see if it is hot, and burn a few times on the edge.
According to the thickness of the embroidery chapter to determine the temperature, thicker, must be higher temperature, hot time is longer.
For a particularly thick embroidered chapter, you can burn it a few times on the reverse side.
Pay special attention: for embroidered chapters with sequins or bright exterior (because the sequins are all plastic products) must be a layer of cloth and low temperature ironing (below 150 ° C), or directly with a steam iron.
Or put a layer of damp cloth on top. In order to avoid excessive temperature, the plastic sheet is condensed.
The best way is to use a needle thread to sew a few stitches on the side of the embroidered chapter after ironing, so that it is more solid and very compliant.
If there is no iron in the house, you can also sew the embroidered chapter on the clothes directly with the same color.
Now found that the light fabric, such as some light down jacket, rain cloth fabric, leather, anti-fur hot effect is not particularly good, it is best to burn it, it is best to sew!